b'To the Finish Linemesh in increments of 800, 1,200 and 2,400 mesh. Previously, these finer sizes were available only in a resin-bond system, which would not work on composite materials.Glue and GritFounded in 1892 by Bradford H. Divine with the purpose of supply-ing high-quality buffing wheels for industrial applications, Divine Bros. Co. has evolved to offer a com-prehensive line of finishing prod-ucts. Bradford W. Divine is company president.Forpolishingpurposes,one product that the Utica, New York-based company manufactures is NORaX U936 engineered abrasive belts have multiple layers of abrasive in each belt.Norton | Saint-Gobain AbrasivesNEW SOLID END MILLSCERAMIC END MILLS CARBIDE END MILLS Offers up to 10X higher productivity over standard Provides 25-50% higher performance in most applications, carbide solutions, bringing tremendous cost savings from full slotting to heavy profiling to fine finishing Our toughest ceramic material combined with a Its sub-micron carbide offers toughness combined with high unique, high-efficiency flute geometry wear resistance to allow for longer tool life Extreme versatility allows for maximum removal rates The PVD coating provides capability for higher speeds, on a wide range of material especially in HRSA materialsGreenleaf Corporation Greenleaf Corporation | 18695 Greenleaf Drive | Saegertown, PA 16433 | 800-458-1850 | 814-763-2915is ISO 9001 Certified Visit greenleafcorporation.com for more information! [email protected] | www.greenleafcorporation.com@2023 Greenleaf CorporationFinishing.indd 20 6/15/23 1:49 PM'