b'Deburred Without Delay The ease of setup is largely due to our Fastsimu pro-gramming and simulation software, he said. It allows you to import the CAD model and generate the tool-Ohio, said the companys self-contained robotized fin- paths, the inspection points, check for collisionsall ishing cell comes equipped with an industrial robot andoffline. Theres no more standing on the shop floor with gripper system, an automatic toolchanger and a servo- a teach controller nudging the head this way and that or powered rotary workholding table and can have elec- trying to figure out how much wheel pressure to apply. tric or pneumatic spindles. The RFC is easy enough toAnd because theres a toolchanger and the option for set up that its suitable for low-volume, high-mix work. a tool magazine, you can easily switch to whatever de-Burning BurrsImagine a process that can completely deburr a part in less time than it took to read this sentencemuch less time. The thermal energy method removes burrs, flashing and trapped particles from practically any workpiece in just a few milliseconds. TEM works by placing a workpieceor hundreds of workpiecesin a sealed, pressurized chamber, filling it with a mixture of methane gas and oxygen and then introducing a spark. The resultant explosion generates a 3,316 C (6,000 F) heat wave that instantaneously vaporizes burrs and loose matter but leaves the workpiece undamaged.Bruno Boutantin, globalmarketing learn moreFor more information about Extrude Hone, call800-367-1109 or visit www.extrudehone.com.10,335,870Extrude Hone36MARCH 2020Deburring.indd 36 2/14/20 3:16 PM'