b'B. TaylorThe parts in the vise are ready for machining (left). Displayed are the different gauge blocks with the key blanks out of the vise, along with a couple of finished keys (right).blanks out of the vise, along with ahave a 0.35" thickness, so I made aoperations.couple of finished keys. The partsgroove on one end of the 0.4" blockOn the right side of the vise, are cut with a 0.375" endmill, so ato ensure that it is put in correctly.there are 1.15" between the vice 0.4" block is put between two partsI find that doing details like thisjaws. Note in Figure 4 on Page 10 for clearance. These gauge blockssaves aggravation with repetitivethat there are two blocks on the ctemag.com/cteguide.com9MachinistsCorner.indd 9 11/16/22 10:33 AM'