b'\x1b\x1a\x19 \x1f\x18\x1d\x17\x16 Machinists Cornerleft. They add to the 1.15" and are placed between the left ends of the jaws against the bed. They ensure that the jaw faces stay parallel when clamped and securely clamp the parts. Dont leave them out.A vise stop is used to set the X dimension, and a pair of 0.5"-thick parallels are placed in the vise to set the Z dimension. The six pieces on the right in Figure 4 are placed on the parallels, and everything is squared up with slack removed. Then the vise is clamped. Dont leave out the two blocks on the left. B. TaylorThe gauge blocks are made of 400 series stainless, so they canFigure 4) to pluck the three un- removed when the parallels come be heat-treated. That stuff is nicelyclamped blocks out of the setupout, the blocks annoyingly will fall magnetic, which means that youbefore the parallels are removed.into the vise cavity. Then push the can use a magnet on a stick (seeIftheunclampedblocksarentrun button, and away you go.CTEThis eye-opening factshocks our competition.100% of CTE subscribers request our magazine.Thats right. 100% . No padding. Noller. ADVERTISE WITH US.Find out more at www.ctemag.com/advertise.10DECEMBER 2022MachinistsCorner.indd 10 11/16/22 10:33 AM'