b'setting to another in seconds. a part is clamped on its OD andjaw does the job.Its important to recognize thatthe diameter being clamped is lessStop Jaws are available for three-, Stop Jaws dont do the work of piethan the length being clamped,four- and six-jaw chucks 152.4 mm jaws or any soft jaws in which a partusing only one work stop on oneto 381 mm (6" to 15") in diameter.CTErequires a large angular contact area.A work stop can be used on the outside of a Stop Jaw to clamp a part on an inside surface. For exam-ple, with a cylinder clamped on its ID, its entire OD can be machined.With a work stop used on thePlunging and slotting - fast and precise inside of a Stop Jaw and a part clampedonanOD,machining through a part is no problem. Ifcool millingFAST MILLINGdrilling and milling with one toolhigh cutting speed and feedhigh chip removal rateVARIOUS OPERATIONS Vertical plunging (drilling)Slotting and pocket millingSide millingRoughing and nishingfrom .039, length up to 5xdIntegrated coolant ductsB. TaylorA Stop Jaw and its associated work stop and stop retainer are shown (above).An assembled Stop Jaw is displayed (left).Mikron Corp. MonroeMonroe, CT 06468mmo@mikron.comwww.mikrontool.comB. Taylorctemag.com/cteguide.com21MachinistCorner.indd 21 4/16/20 12:45 PM'