b'High-Speed Holemakingapplications.Early five-axis machines can have give in the tables, Ruegseg-ger said, but this has been largely remedied. Still, the fixturing must be adequate to the application.Pilger said the material affects both the tooling and programming of a machine.In aluminum applications, he said, its possible to drill at speeds of up to 650 sfm. When it comes to materials like Inconel, titanium or special alloys, the speed has to be substantially reducedsometimes to 70 to 100 sfm. Drilling some types of high-temperature alloys too fast will literally result in enough heat to workharden the part. On the other hand, running carbide drills tooAllied Machine & Engineeringslow in many types of steels can re- The material-specific GEN3SYS XT Pro insert combines a substrate coating and geometry sult in a built-up edge and destroydesigned to achieve optimal results in different ISO material classes.THE HIGHEST QUALITY FROM EVERY ANGLECutting tools like ballnose, corner radius, barrelLINEAR CHISEL ENLARGED VIEWLINE FORMINVISIBLE ODLESS THAN 0.002MM RUNOUT shape ballnose, and double corner radius endmillsFOR CENTRE OF CHISEL ACCURACY& BALLON CUTTING EDGE WITH CUTTING SHARPNESS +/-0.002MM TRANSITION REFERENCE TO SHANKare widely used in diemold, aerospace, power generation and other industries. The surface nish,A 0.002mm Aquality, accuracy, and runout are critical for the performance and cutting life in all applications.To increase the stiffness of the C-axis, the MX7 ULTRA combines developments to the nanometre or micro degree resolution in the linear and rotary axis, tuning parameters, several system enhancements, and major mechanical changes. Smoothing parameters provide even greater control for the velocity and acceleration or deceleration along with machine jerk limits. North Building,BALL RELIEF UNIFORM GRINDSMOOTHERMTC FOR DIAMETER AT 45LINES ALONG BALLGASHVARIATION UNDER Level 3237406DEGREES SURFACE SURFACE +/0.0025MM20SEPTEMBER 2022 Holemaking.indd 20 8/18/22 9:38 AM'