b'depth using the operators digitalwith one end of the plate hang- table went home but not before readout. Enter that value in theing outside the doors. For what- leaving a big gash in a door as canned cycle that runs the tool.ever reason, the machinist homeda result of the edge of the plate The only catch is that the opera- the machine. In rapid mode, theslamming into it.CTEtors screen must be zeroed in to Z beforehand to the tip of the coun-tersink tool, or the value shownYour Eye Inside on the screen wont make sense. Dimensions for countersunk holes are generally not too critical. TheseFast, reliable metal machiningdimensions are used mostly for& EDM inspection withflat-head screws and lead-ins for tapped holes. Hawkeye Rigid BorescopesSometimes, youmust leave a machines doors or windowsopen to accommodatea part or feature Rie barrel seen with Diesel injector withBurr in a cross hole viewed of a part. Make aHawkeye Pro Slim 17 a Hawkeye Pro Hardy 7 with a Hawkeye Pro Slim 7a mental note to be Visit us at: Bring Your Parts to the Show extra-cautiousfor Inspection Solutions!when doing this. Booth #1517Long Beach, CASeptember 24 - 26, 2019n Be especially careful when running large parts with the ma-chines doors or windows open. Occasionally, youll run into ca-pacityissueswithmachines. These issues often can be over-come with thoughtful planning. Sometimes, you must leave a ma-chines doors or windows open to accommodate a part or feature of a part. Make a mental note to be extra-cautious when doing this. Its a recipe for crashing because your travel may be limited to the openings of the doors or win-dows, not the total travel of the machine table. I once saw a nasty crash when a machinist clampedgradientlens.com 800.536.0790Made in USA a long plate to a machine table ctemag.com/cteguide.com25ShopOps.indd 25 6/14/19 3:37 PM'