b'ARCHCUTTINGTOOLS.COM Catching 22However, producing a cutting edge with the correct hone is a balancing act, according to Craine. Too much of a hone and the tool performs like it is dull, while an edge that is too sharp is prone to chipping.To further enhance its T-A drills, Vanderbeck said Allied Machine performs a proprietary process affectionately called the ultragrind to create the ideal cutting edge for BRINGING A NEW SYNERGYincreased tool life and chip control. That process mini-mizes fracture points along the cutting edge, he added. TO CUTTING TOOL SOLUTIONS Without proper chip formation, titanium chips can be-come like ribbons and hard to evacuate. If you are drill-ing anything more than three times diameter, that long ribbon will bind up and seize your tool, Vanderbeck said. It goes bad real quick, and a lot of times you dont have time to hit that e-stop. By the time you see it, it is too late.Keep It CoolTool coatings and coolant play important roles when combating the high level of heat generated from cut-ting titanium. For coatings, Vanderbeck recommends Specials Integral Shank Indexables SolutionsARCH offers integral shanks in almost any connection type and size, eliminating the need for a tool holder and collet.Other benefits include increased rigidity and reduced runout. This enables faster feed rates, better finish, and ultimately contribute to higher throughput.New videos coming soon!Like and Subscribefor more Mitsui Seiki42JULY 2019 Titanium.indd 42 6/17/19 10:30 AM'