b'scenario, never knowing when a thicker or harder spot is going to happen or when the tool is going to break down a little more.Feeding higher when appropriate enables end users to reduce cycle times. Caron Engineering doesnt pro-vide any guaranteed reduction but reports that it ranges from 20% to 60% with TMAC. In the titanium area, it is rare to ever see under a 30% reduction, Caron said. The cycle time reduction gets higher as20192019the materials get more challenging. RELEASEAlthough successfully completing a titanium part can take precedence over speed, every aerospace company, for example, is being asked to reduce pro-duction costs, according to Caron, and tool monitor- Double sided multiform inserts for straight threadsing is an effective way to minimize expensive parts be- Single sided multiform inserts coming boat anchors. We give them the ability tofor NPT & tapered threadsprevent scrapping a part by removing a tool when it isSolutions for internal & externalsupposed to be removed. threading applicationsThe system also helps overcome the challenge ofFour Point System of Rigidityfinding workers with the ability to hear and under-stand when a tool breaks down, Caron added. Typi-cally, there needs to be an operator right there keep-ing an eye on the machine. We can do this type of work automatically, so it allows the machine to run unattended.CTE 800-847-3234 | advent-threadmill.com|100% Made in USActemag.com/cteguide.com47Titanium.indd 47 6/17/19 10:30 AM'