b'Productive Timesindustry, Schwierking said he can tell when a toolmaker is willing to make the changes needed to get a tool functioning properly.They either will tell you right off the bat that theyre into making the changes to whatever you need, he said, or they just say that they cant do that. There was never a time that they said, We dont think were going to be able to figure this out.While not an off-the-shelf prod-uct, Quality Chaser reports that it often makes custom chasers for customerstomaximizeperfor-mance and customer satisfaction.With expert engineering and te-nacity, this toolmaker came through for us and has become our go-to sourceforthreadingchasers, Schwierking said. It also didnt hurt Quality Chasers position as the leading candidate because its lead times were at least a third quicker and its prices at least half compared to the previous chaser supplier.Confident that Quality ChaserConcept Metals Groupwouldnt give up, he worked withThe die head is displayed in a manual Brown & Sharpe screw machine.the toolmaker to suggest modifi-cations to cutting geometry, suchand giving him feedback for whatfeedback, he said a new iteration as the relief angle, clearance angle,was going on with the insert so thatwould arrive.chipbreakerandhone.Hesaidthey could make some adjustmentsThey were responding pretty Denny Kubczak, sales and serviceand then give us another iterationquicklyconsidering,Imassum-specialist, is his main contact there. to try, Schwierking said. ing, they had a schedule that they Filtermist_Ad_CTE_847_Layout 112/9/202:26 PMPa week or so after providingneeded to meet, and I didnt expect We just (kept) working with himAOIL MIST & SMOKEIN YOUR SHOP?www.mistcollectors.com Tel: 1-800-645-4174Low-Cost, Highly Efficient Mist and Smoke Collectors Designed Specifically for the Metalworking Industryctemag.com/cteguide.com59ProTimes.indd 59 3/16/23 2:04 PM'