b'\x1b\x1a\x19 \x1f\x18\x1d\x17\x16Get With the Programterms of overall speed of program- bottlenecks on other machines.and then well auto-tool the part ming and nesting efficiency, Hun- When we purchased posts for otherfor each machine that it can be pro-ley said. Programming was up tomachines, such as our Wiedemann,cessed on, which means that its 75% quicker, and nesting efficiencywe were able to move work over toready to nest on any machine.could be as much as 14% better.it in a matter of hours, whereas pre- In 2014, the company upgraded The machine path optimization al- viously it would take three days. its standard free-form nesting to lowed jobs to run faster with codeTechnology-specific functionalityJetCAM Internationals free-form, generated by JetCAM. also has saved time for ASCO Powerhigh-performance nesting module. In addition to new machines run- Technologies. Tool Teach has beenUsing its time-based nesting algo-ning JetCAM Expert, he set aboutparticularly instrumental in stream- rithm, this delivered on average a replacing the remaining nesting sys- lining the process of applying punchfurther 4% savings on material.tems and talked about post-pro- tool hits to complex components. Continually looking for areas of cessors with Duluth, Georgia-basedWe adapt to what engineers re- improvement, ASCO Power Tech-NestOne Solutions LLC, a distribu- quest on the part with teach mode,nologies identified that scheduled, tor for JetCAM International. Hunley said. We can teach a spe- fully dynamic nesting across all ma-We needed a stable and con- cial tooling arrangement, whichchines would provide more benefits. sistent solution for all of our ma- will then be applied automaticallyThe company reviewed manufactur-chines, Hunley said. After weon all parts with elements of theing execution systems, finally set-initially got JetCAM, we quicklysame geometry. JetCAM automati- tling onThe Aquila Group Inc.s Dy-identifiedthatwewereseeingcally cleans the file during import,namic Machine Managementdue to 10JUNE 2021 GetwiththeProgram.indd 10 5/14/21 1:37 PM'