b'SEQUENCE VALVES.Vektek LLCs in-the-port sequence valvesTURNING.Ingersoll Cutting Tool Co.s SuperTurnZ is a system lessen the need for difficult multiple-circuit deep-hole drillingfor multidirectional turning that uses the front and back cutting and complex circuit design. Users save time and money byedge of a four-corner insert in a single tool. It represents a reducing design time and deep-hole drilling. The sequence valveshighly productive alternative to conventional turning in which allow a single circuit to feed up to a dozen individually sequenced80- and 35-degree corner inserts are fed in the same direction. devices. The valves install directly into the device port and can beSuperTurnZ instead utilizes all four directions available on adjusted individually to time clamps.conventional two-axis lathes to maximize material removal. Vektek LLC; www.vektek.com Ingersoll Cutting Tool Co.; www.ingersoll-imc.com10X HIGHER PRODUCTIVITY!XSYTIN\x1f360 CERAMIC END MILLSDelivers tremendous cost savings! High removal rates on a wide range of materialsFINALLY\x1f A SOLID CERAMIC END MILLCapable of signi\x1fcantly THAT OUTPERFORMS CARBIDE! increased chip loads versus other ceramic end millsA combination of our strongest ceramic material and a unique cutting geometryVisit greenleafcorporation.com for more information! World leader in ceramic cutting tools!Greenleaf Corporation is ISO 9001 Certified. Greenleaf Corporation | 18695 Greenleaf Drive | Saegertown, PA 16433 | 800-458-1850 | 814-763-2915 2021 Greenleaf Corporation sales@greenleafcorporation.com | www.greenleafcorporation.com MPR.indd 5 5/14/21 1:32 PM'